If “Ready to Connect” is not displayed on screen, please wait 1 minute before trying any of the below steps.
No response after clicking the top of the Orro switch?
You must enable the connection mode on your Orro switch. This is achieved by pushing the top of the switch 3 times quickly in succession. Make sure to fully click the top of the switch screen.
Once you triple click you should see the enabling connection screen:
Then you will see the ready to connect screen below:
Is the switch screen stuck on “Enabling Connection”?
Switch is not responding to triple clicking?
The Orro switch wifi network may take a minute or two to enable. If the “Ready to Connect” screen still does not appear after 2 minutes, pull the air gap switch located at the very bottom of the Orro switch to reboot.
The air-gap switch is a small slider at the bottom of the switch. When pulled out (away from the wall) it disconnects electricity.
STEP 1: Pull out the air gap switch
STEP 2: Wait 10 Seconds
STEP 3: Push tab back into switch and let switch boot up.