Click the top of your Orro switch 3 times to activate the switch wifi network
Before beginning app setup, you must enable the connection mode on your Orro switch. This is achieved by pushing the top of the switch 3 times quickly in succession. Make sure to fully click the top of the switch screen.
Once you triple-click you should see the enabling connection screen:
Then you will see the ready to connect screen below:
If the triple click is not working
Please try again with three clicks in quick succession. If the switch still does not respond immediately, wait 1 minute and try again.
If the above steps do not work, please reboot the by pulling the air-gap tab. The air-gap switch is a small slider at the bottom of the switch. When pulled out (away from the wall) it disconnects electricity.
STEP 1: Pull out the air gap switch
STEP 2: Wait 10 Seconds
STEP 3: Push the tab back into the switch and let switch boot up.